Logging in to E-Banking with the Access Card Display
How to log in
How to log in
- Select UBS logins
- Enter your contract number on the login page and select Continue
- Select Access Card as the login method
4. Switch on the Access Card Display by pressing 
or by inserting it into your card reader.
5. Enter your PIN and press 
6. Enter the six-digit code displayed on the login page into the Access Card Display or the card reader and press
Security note: The six-digit code displayed on the login page is always composed of six numbers. Should the number displayed have fewer than six digits, stop the login and contact our support team immediately.
7. Transfer the eight-character code from the Access Card Display or the card reader to the login page and select Login.
Set or change a PIN
Set or change a PIN
When you activate a new Access Card Display, you must set a personal PIN. You can also change your PIN again later.
or by inserting it into your card reader.
2. If you’re activating a new Access Card Display, you can immediately set a PIN and press .
If you would like to change a PIN you have previously set, press MENU on the Access Card Display, or 
on the card reader. Then enter a new PIN and press .
Your new PIN must contain between six and eleven digits
3. Re-enter the new PIN and press .
4. Your new PIN will be valid immediately.
Please bear in mind: Your Access Card Display is blocked after entering the PIN incorrectly five times. You should therefore contact our support team after four incorrect entries.
Was this page helpful?
Please enable javascript in your browser and retry.
The feedback component cannot be displayed.
FAQ
FAQ